Slide both live edge slabs together and screw the pocket jigs.You can also glue the edges of live edge slab at this points also. Glue and install your biscuits into the cut slots.By having both biscuit joints and pocket hole joinery, we ensured that the table would be built strong, and prevented any future bowing of the table slabs. We alternated which slab we drilled the pocket holes from as we went. We put them in between all the biscuit slots and at the ends of the live edge slab. Ensure these don't line up with the biscuit slots. Using a pocket jig drill pockets holes in the bottom side of your table.You may want to use a scrap piece of wood that is the same thickness as your live edge slab first to ensure the biscuit is cut in the correct position. Cut your biscuit slots so the biscuit is in the center (from top to bottom) of the live edge slab.We wanted a joint 4" from each end and than at every 12" throughout the slab. Mark out where you want your biscuit joints to be. Next, we added biscuit joints to strengthen the connection between the two slabs.We used our track saw to complete this cut, however, if you don't have a track saw you could use a circular saw and guide (which could even be a 2x4 clamped to the table!) to make these long cuts.We wanted to make sure that the seam where the two slabs met would remain in the center, so cut 5" off each slab (cut down to a final width of 20 1/4"). We found 50 1/2"too wide for our kitchen table and decided we wanted a final table width of 40 1/2", a total of 10" less. The live edge slabs we had were originally 25 1/4" wide. The first step is deciding on the width of your table.Start by unboxing your live edge countertop slabs and placing them on work horses. Two days later we had a gorgeous table with a light, white tabletop. From cutting to attaching, to sanding and staining. We did this entire live edge table in just two days. We were so happy with how our table turned out! It was the perfect piece to accent our new dining room. It was a pleasure showing you all how to build a modern table. The final step is to varnish your table so that it’s protected and ready to be used on a daily basis. You can always add more stain, and each additional layer will usually make your stain deeper. If you’re not sure how long to let it sit, my suggestion would be, a) try it on a scrap piece that you cut off first, or b) do a small amount and let it sit for a shorter amount of time first, then do subsequent coatings. We used a White Linen Stain which looked beautiful when it was dry! We wanted the white to really soak into the wood, so we applied a generous amount of stain and let it sit for a couple of minutes before we wiped it off. Here’s a great step-by-step guide for how to stain a table.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |